Central Heating System is a system that comprises components of heating, ventilation, and air conditioning system. These systems can cool as well as warm the interior spaces. This system provides warmth to several spaces inside a building.
Installation of this system is a very difficult job, and it requires careful planning and a sound understanding to do this job. It is advisable to have a thorough knowledge of the entire necessary details.
A large part of the installation of this Central Heating can be done yourself, such as choosing the radiator and boiler and laying the pipe in the room.
You can also install the Central Heating unit on your own, but you just need to contact a certified contractor to connect the boiler to the gas supply and investigation the entire system to see if it’s safe for use and effective or not.
Following eight steps which you need to follow for the installation of a Geothermal Heating and Cooling unit on your own-
- Research for the right equipment- Try to choose a large gas boiler that can heat your home and supply hot water to your bathtub and sink. Try to have energy efficient boiler to avoid higher monthly expenses due to the loss of heat from the boiler. Select the radiator that offers adequate heating capacity.
- Create a road map of the central heating system you are going to install- this road map will behave as a blueprint. Install the boiler at that place that allows for easy connection of the pipes, as well as the gas main, and offers a ventilation shaft to the roof. Install the radiator beneath the window to combat the heat loss through the window.
- Buy all the necessary items required for the installation of this Heat Pump Hydronic Heating system.
- Install the radiators- the radiators must be installed at a certain height above the floor. Install a wheel valve on the flow concentration and a lockshield valve on the return connection
- Lay the copper pipes with compression joints from the radiators to the boiler.
- Install the control system
- Shut off all the water and gas supply and install the boiler by following the manufacturer’s instructions.
- Commission the heating system by closing all the vents on the radiators. Activate the heat pump and re-vent the system.
SNUG Hydronic Heating 